Ligowave LigoDLB Router driver for Windows 7 - Ligowave LigoDLB Router driver from Ligowave for

Ligowave LigoDLB Router 7.53

Ligowave LigoDLB Router driver from Ligowave for OS Independent

Ligowave LigoDLB Router driver from Ligowave for OS Independent

Publisher review for Ligowave LigoDLB Router 7.53:

Before install Ligowave LigoDLB Router 7.53you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Ligowave LigoDLB Router . We recommend to always use most recent version of a driver.

What’s new in 7.53 firmware release- Upgrading notes: 7.53 iPoll 3 does not connect to previous iPoll 3 firmware versions if encryption is enabled.
- LigoDLB (7.53) iPoll 3 is only compatible with LigoDLB series
- LigoDLB (7.52) iPoll 2 is compatible with Deliberant APC (7.02) iPoll 2
NEW:- Added operating scenario next to the country code
- Added charts (Device count and Signal level) in Site Survey
- Added Portuguese language support in GUI
- Added ARP table in Status | Network section
- Added QoS statistics in GUI
- Added Spectrograph for Spectrum Analyzer in GUI
- Added snmptrap utility to send traps
- Added option to display friendly name on browser tab
- Added option to set WPA2-PSK only
- Added LIGO-WIRELESS-MIB
- Added SNMP traps
- Added SSID failover for CPE
- Added VLAN option on PPPoE
- Added DFS CAC indicator on GUI
- Added interface counter stats to WNMS
- Added QoS functionality for data and voice
Improvements:- Major ipoll V3 improvement
- Improved GUI caching mechanism
- Improved password security algorithm
- Improved Statistics polling when many clients are connected
- Improved CPU load advertising when many clients are connected
- Improved Autorate algorithm
- Limited max VLAN ID to 4094 in GUI
- Improved history sorting for Ping Tool Results
- Updated Japan (JP) frequency list
- Updated South Africa (ZA) country code
- Removed username length limit
- Updated Egypt country code
- Updated error messages with “Incorrect” instead of “Bad”
Fixes:- Fixed issue when WNMS showed constant number for rx/tx bytes of interface
- Fixed issue when SNMP stopped working if username was changed
- Fixed Ping&trace history issues
- Fixed Site Survey notification when radio is disabled
- Fixed interference detected and stopped traffic issues for 11n mode
- Fixed issue when ‘Status->Information’ displays secondary ip address
- Fixed issue when traceroute can’t route to some IP’s
- Fixed issue when station can’t connect to UBNT with WPA2-TKIP
- Fixed issue when using iPoll2/3 drops packets on low MCS
- Fixed device discovery problems with bonjour and ssdp using different subnets
- Fixed WDS table overfilling issue
- Fixed issue when Site survey reports wrong security
- Fixed issue when station can’t assoc to MikroTik AP when “Network mode” is changed from”Bridge” to “Router”
- Fixed Ping&trace tool does not report “network unreachable”
- Fixed “Invalid message” when change of user account credentials has failed
- Fixed Large amount of DNS queries (attack) issue
- Fixed issue when GUI does not add static routes and port forward rules
- Fixed Power saving issues with old devices

Operating system:
OS Independent